H3C Technologies H3C SR8800 - Manual (Page 185)

173
Table 7 Information channels and output destinations
Information
channel
number
Default
channel name
Default output
destination
Description
0 console Console Receives log, trap and debugging information.
1 monitor Monitor terminal
Receives log, trap and debugging information,
facilitating remote maintenance.
2 loghost Log host
Receives log, trap and debugging information
and information will be stored in files for future
retrieval.
3 trapbuffer Trap buffer
Receives trap information, a buffer inside the
router for recording information.
4 logbuffer Log buffer
Receives log and debugging information, a
buffer inside the router for recording
information.
5 snmpagent SNMP module Receives trap information.
6 channel6 Web interface Receives log, trap, and debugging information.
7 channel7 Not specified Receives log, trap, and debugging information.
8 channel8 Not specified Receives log, trap, and debugging information.
9 channel9 Log file Receives log, trap, and debugging information.
NOTE:
Configurations for the eight output destinations function independently and take effect only when the
information center is enabled.
Outputting system information by source module
The system is composed of a variety of protocol modules, board drivers, and configuration modules. The
system information can be classified, filtered, and output according to source modules. You can use the
info-center source ? command to view the supported information source modules.
Default output rules of system information
The default output rules define the source modules allowed to output information on each output
destination, the output information type, and the output information level as shown in Table 8 , which
indicates that by default and in terms of all modules:
• All log information is allowed to be output to the web interface and log file; log information with
severity level equal to or higher than informational is allowed to be output to the log host; log
information with severity level equal to or higher than informational is allowed to be output to the
console, monitor terminal, and log buffer; log information is not allowed to be output to the trap
buffer and the SNMP module.
• All trap information is allowed to be output to the console, monitor terminal, log host, web interface,
and log file; trap information with severity level equal to or higher than informational is allowed to
be output to the trap buffer and SNMP module; trap information is not allowed to be output to the
log buffer.