H3C Technologies H3C SR8800 - Manual (Page 192)

180
Step Command Remarks
4. Enable the display of trap
information on a monitor
terminal. terminal trapping
Optional.
Enabled by default.
Outputting system information to a log host
Step Command Remarks
1. Enter system view. system-view N/A
2. Enable information center. info-center enable
Optional.
Enabled by default.
3. Name the channel with a
specified channel number.
info-center channel
channel-number name
channel-name
Optional
See
Table 7 for default channel
names.
4. Configure the output rules of
the system information.
info-center source { module-name |
default } channel { channel-number
| channel-name } [ debug { level
severity | state state } * | log { level
severity | state state } * | trap
{ level severity | state state } * ] *
Optional.
See “
Default output rules of system
information .”
5. Specify the source IP address
for the log information. info-center loghost source
interface-type interface-number
Optional.
By default, the source interface is
determined by the matched route,
and the primary IP address of this
interface is the source IP address of
the log information.
6. Configure the format of the
time stamp for system
information output to the log
host.
info-center timestamp loghost
{ date | iso | no-year-date |
none }
Optional.
date by default.
7. Set the formation of the system
information sent to a log host to
UNICOM.
info-center format unicom
Optional.
H3C by default.
8. Specify a log host and
configure the related output
parameters.
info-center loghost [ vpn-instance
vpn-instance-name ]
{ host-ipv4-address | ipv6
host-ipv6-address } [ port
port-number ] [ channel
{ channel-number |
channel-name } | facility
local-number ] *
By default, the system does not
output information to a log host. If
you specify to output system
information to a log host, the
system uses channel 2 (loghost) by
default.
The value of the port-number
argument should be the same as
the value configured on the log
host, otherwise, the log host cannot
receive system information.
Outputting system information to the trap buffer