H3C Technologies H3C SR8800 - Manual (Page 42)

30
Step Command Remarks
1. Enter system view. system-view N/A
2. Enter NQA test group view.
nqa entry admin-name
operation-tag
N/A
3. Enter test type view of a test
group.
type { dhcp | dlsw | dns | ftp |
http | icmp-echo | snmp | tcp |
udp-echo | udp-jitter | voice }
N/A
4. Configure the description for
a test group.
description text
Optional.
By default, no description is
available for a test group.
5. Configure the interval
between two consecutive tests
for a test group.
frequency interval
Optional.
By default, the interval between
two consecutive tests for a test
group is 0 milliseconds. Only one
test is performed.
If the last test is not completed
when the interval specified by the
frequency command is reached, a
new test does not start.
6. Configure the number of
probe operations to be
performed in one test.
probe count times
Optional.
By default, one probe operation is
performed in one test.
Not available for voice tests, Only
one probe operation can be
performed in one voice test.
7. Configure the NQA probe
timeout time.
probe timeout timeout
Optional.
By default, the timeout time is 3000
milliseconds.
Not available for UDP jitter tests.
8. Configure the maximum
number of hops a probe
packet traverses in the
network.
ttl value
Optional.
20 by default.
Not available for DHCP tests.
9. Configure the ToS field in an
IP packet header in an NQA
probe packet. tos value
Optional.
0 by default.
Not available for DHCP tests.
10. Enable the routing table
bypass function.
route-option bypass-route
Optional.
Disabled by default.
Not available for DHCP tests.
Scheduling an NQA test group
You can schedule an NQA test group by setting the start time and test duration for a test group.
A test group performs tests between the scheduled start time and the end time (the start time plus test
duration). If the scheduled start time is ahead of the system time, the test group starts testing immediately.