RISCO Group Gardtec GT600 - Manual (Page 44)

Page 42
GT 600 / 601 Engineer’s Reference Guide
22) Press No. The display will show:-
23) Press Yes. The display will show:-
With the Bell Tamper Ring On tampering the Bell Box will also trigger the Bell
Output from the control panel. With Bell Tamper Ring Off, the Bell Trigger from
the panel is not activated.
24) Press No until your required setting is displayed,
then press Yes. The display will show:-
25) Press No. The display will show:-
26) Press Yes. The display will show:-
27) Press No until the required setting is displayed,
then press Yes. The display will show:-
28) This concludes the programming for
Bells & Sounders. Press 0 (zero) to return to:-
Or
Press 0 (zero) until the display shows:-
Program Bell
Tamper Mode ?
Program Bell
Tamper Mode ?
Program Bell
for Part-Set ?
Program Bell
for Part-Set ?
Part-Set Bells
= On
Bell Tamper Ring
= On
Program . . . . _ _ _
Bells / Sounders ?
01 Jan 00: 00: 01