RISCO Group Gardtec GT600 - Manual (Page 6)

7) The display will show:-
This may show for several minutes.
8) Enter Engineer code.
(1234 default EN2). The display will show:-
Note: User Codes and Engineer Codes MUST be six digits in
length for EN3 installations. (See Page 2).
9) Enter the Authorisor code. The Authorisor code is
the Master User, (default 5678 EN2).
The display will show:-
Note: It may be required that an engineer has to be authorised by a user before access to the
Engineer mode is granted.
10) Press Yes. The display will show:-
From this point the panel is in Engineer Mode and all Tampers will be disabled.
Page 4
GT 600 / 601 Engineer’s Reference Guide
Enter Authorisor
Code . . . . . .
Do you want to . .
Use ENGNR. Mode ?
Program Zones . . . . - - -
Zones ?
Please Wait