RISCO Group Gardtec GT600 - Manual (Page 75)

Page 73
GT 600 / 601 Engineer’s Reference Guide
Programming Service
Within this section you will program the Service Timer. The Service Timer has the
ability to Lock a user out of the system when the Service Time expires. Trading
Standards may take action if a Lockout occurs and no Service Contract exists. Please
use with care.
1) Enter into Engineer Mode
To do this follow Steps 1 to 4 on page 11
With the display showing:-
2) Press No thirteen times. The display will show:-
3) Press Yes. The display will show:-
4) Press Yes. The display will show:-
5) Press Yes if you require to save to PTM.
Otherwise
6) Press No. The display will show:-
7) Press Yes if you require to load from the PTM.
Otherwise
8) Press No. The display will show:-
Note: To transfer data to and from the PTM connect the cable to CON4.
(Part no 1CB 6049)
Note: When data transfer is in progress, the LED on the PTM will flash rapidly.
Program . . . . _ _ _
Zones ?
Program . . . . _ _ _
Service / PTM ?
Save Panel NVM
to PTM ?
Load Panel NVM
from PTM ?
Service Timer
= Off
Gardtec60x xx-xx
ENx 50Hz Ok?
Version