Honeywell INTELLIKNIGHT 5820XL User Manual
Page 106
IntelliKnight 5820XL Installation Manual
6-4
151209
- Accept Configuration
1. If you are ready to make the JumpStart configuration permanent,
select .
2. The system will ask you if the installation contains any addressable
duct detectors. If there are none, select
for No and skip to Step
8. If the system contains duct detectors, select
for Yes and con-
tinue with Step 3.
3. From the list that displays, select the 5815XL device that contains
the duct detectors.
4. The first photoelectric or ionization detector on the system will dis-
play. Select
for DUCT and
for NonDUCT.
5. Press
to select the next detector. Select
for DUCT and
for NonDUCT. Continue until all duct detectors have been selected.
(Note: You can move backwards through the list with
.)
6. When you reach the last detector on this device, press
.
7. The system will ask you if there are more duct detectors in the sys-
tem. If there are, select
for Yes and repeat from Step 3. If there
are no more duct detectors, select
for No and continue with
Step 8.
8. The system will restart in 10 seconds. You can press
to restart
immediately.
9. After the system resets, it will use the new JumpStart configuration.
- Enter Programming
If you want to go directly to Program Mode to configure any devices,
press
. The Programming Menu appears and you can begin
programming.