1 flush mounting, 1 flush mounting -12 – Honeywell INTELLIKNIGHT 5820XL User Manual
Page 52
IntelliKnight 5820XL Installation Manual
4-12
151209
The 5860 comes from the factory fully assembled. You must disassemble it for
mounting. To disassemble the annunciator, use a 5/64 hex wrench to remove the set
screws, located on the bottom of the annunciator bezel. (See Figure 4-11 for location
of the set screws.)
Figure 4-11 Annunciator Back Box and Bezel Details
4.5.1.1 Flush Mounting
This section of the manual describes flush mounting. You can flush-mount with or
without an electrical box.
Set screw location.
Loosen set screws to remove bezel
when disassembling annunciator.
Knockout holes
Holes for surface mounting.
Holes for inserting
wires for flush mounting
(located in all corners).
Stand-off
(throughout)
Screw for placement
of mounting wires
(top and bottom).