Honeywell INTELLIKNIGHT 5820XL - Manual (Page 181)

System Operation
151209 8-7
• All four lines of the LCD are not full.
This test takes approximately 15 seconds to complete. You can press any key to end
manually while the test is still in progress. When the test ends, you will be returned to
the <Test Menu>.
8.5.9 Conduct a Walk Test
1. From the Main Menu, press for System Tests.
2. Select for Walk Test-No Rpt. The LCD will display “WALK TEST STOPPED”
on Line 1 and “ENTER = start test” on Line 2. If you select this option, central sta-
tion reporting will be disabled while the test is in progress.
Or
Select for Walk Test-with Rpt. The LCD will display “WALK TEST STOPPED”
on Line 1 and “ENTER = start test” on Line 2. If you select this option, central sta-
tion reporting will occur as normal during the walk test.
The panel generates a TEST report to the central station when the walk test
begins. During a walk test, the panel’s normal fire alarm function is completely dis-
abled, placing the panel in a local trouble condition. All zones respond as 1-Count
zones (respond when a single detector is in alarm) during a walk test. Each alarm
initiated during the walk test will be reported and stored in the event history buffer.
3. Press to end the walk test. The system will reset. The panel will send a
“TEST RESTORE” report to the central station.
If you do not end the walk test manually within four hours, it will end automatically.
If an alarm or pre-alarm condition is occurring in the system, you will not be able to
enter the walk test.
Note: The panel does not do a full 30 second reset on resettable power outputs. As soon as the device
is back to normal, the panel is ready to go to the next device.
8.5.10 Conduct a Dialer Test
1. From the Main Menu, press for System Tests.
IMPORTANT!
If any alarm verification zones are being used, the user will be asked if they
wish to disable alarm verification during walk test. This occurs for either walk
test option.
ENTER
ACK