FARGO electronic DTC300 - Manual (Page 125)

RESTRICTED USE ONLY Fargo Electronics, Inc.
DTC400/DTC300/DTC300M Card Printer Service Manual (Rev. 1.3) 5-52
Resolving the Image Placement problems (continued)
Step Procedure
4 Verify if the Vertical Image Position Setting is set correctly or incorrectly. See
the graphic below.
a. Adjust the value as described below:
• If the white border is on the top edge of the card, adjust the Vertical value
by +2.
• If the white border is on the bottom edge of the card, adjust the Vertical
value by -2.
b. Click on OK.
c. Run a self-test.
d. If the white border is diminished, continue the adjustment until it is gone.