FARGO electronic DTC300 - Manual (Page 293)

RESTRICTED USE ONLY Fargo Electronics, Inc.
DTC400/DTC300/DTC300M Card Printer Service Manual (Rev. 1.3) 8-39
Replacing the Top Cover Assembly (includes Print Circuit Board)
This procedure applies to these components:
• DTC300 Top Cover Replacement (044304); includes Print Circuit Board
• DTC300 Flip Cover Replacement (044305); includes Print Circuit Board
• DTC300M Top Cover Replacement (044306); includes Print Circuit Board
• DTC300M Flip Cover Replacement (044307); includes Print Circuit Board
• DTC400 Top Cover Replacement (044308); includes Print Circuit Board
Refer to Drawing D900100.
Tools Needed: Torx T-10 Screwdriver, No. 2 Phillips Screw
Driver
Parts Needed: Top Cover Assembly (see above)
Estimated Repair Time: 10 to 20 minutes.
Steps Procedure
1
Caution No. 1: Turn off the Printer and unplug the power cord from
the Printer.
Caution No. 2: Use caution when replacing the Top Cover Assembly
(see above) because the Lid Sensor Switch can break off.
2 If your Printer is equipped with a Magnetic Head Assembly, remove the
Assembly prior to performing this procedure. See
Replacing the Magnetic Head
Assembly (D900050) .
Continued on the next page