FARGO electronic DTC300 - Manual (Page 163)

RESTRICTED USE ONLY Fargo Electronics, Inc.
DTC400/DTC300/DTC300M Card Printer Service Manual (Rev. 1.3) 6-34
Using the Resin Heat, Back (K) option (DTC300M)
Use this option to control the amount of heat the Printer uses when printing with the resin
black panel(s) of a full-color Ribbon or when printing with a resin-only Ribbon by adjusting
the Resin Heat slide. (Note: This control can be helpful for fine-tuning the transfer of resin
text and bar codes.)
Step Procedure
1 Check on the Print Both Sides checkbox or the Print Back Side Only
checkbox to activate the Resin Heat, Back (K) slide.
• Move the slide to the left to cause less heat to be used in the printing
process, causing resin images to be lighter or less saturated.
OR
• Move the slide to the right to cause more heat to be used.