FARGO electronic DTC300 - Manual (Page 304)

RESTRICTED USE ONLY Fargo Electronics, Inc.
DTC400/DTC300/DTC300M Card Printer Service Manual (Rev. 1.3) 8-50
Replacing the Clean Roller Plate (D900102)
Refer to Drawing D900110.
Tools Needed: Torx T-10 Screwdriver, Retaining Ring
Pliers
Parts Needed: Card Cleaning Roller D900040, Retaining
Ring 140048(X1), Wave Washer 130951 (X1)
Estimated Repair Time: 30 minutes.
Steps Procedure
1
Caution: Turn off the Printer and unplug the power cord from the
Printer.
2 Remove the Rear Cover. See Replacing the Rear Cover (D900066) .
3 Remove the Input Door and Right End Cap. See Replacing the Input Door
Assembly (D900148) . See Replacing the Right End Cap (D900065-01 and –02) .
4 Remove the Card Output Door and Left End Cap. See Replacing the Output
Door Assembly (D900092) . See Replacing the Left End Cap (D900064) .
5 Remove the Stepper Motor Idler Pulley (D840888) and the Platen Roller Drive
Gear (D900047). See
Replacing the Stepper Motor Idler Pulley (D840888) and
the Platen Roller Drive Gear (D900047) .
6 Remove the Stepper Motor Assembly. See Replacing the Stepper Motor
Assembly (D900087) .
7 Use a Retaining Ring Pliers remove the retaining ring (140048) from the
Cleaning Roller Shaft.
Continued on the next page