FARGO electronic DTC300 User Manual

Page 95

Advertising
background image

RESTRICTED USE ONLY

Fargo Electronics, Inc.

DTC400/DTC300/DTC300M Card Printer Service Manual (Rev. 1.3)

5-22

Resolving a Ribbon Break Jam Error (continued)

Step Procedure

2

Open the front cover and remove the Ribbon Cartridge.

•

If Ribbon is broken, continue to Step 3.

•

If Ribbon is in good condition, continue to Step 6.

3

Adjust the print offset. See the

Using the Print Top of Form Option

procedure.

If the issue persists, continue to Step 4.

4

Repair the Ribbon and wind up the take-up roll 4 color panels past the
damaged area.

a. Press on the Resume button.

b. If the issue persists, continue to Step 5.

5

Use the Fargo Diagnostic utility to cycle the Printhead to ensure proper
printhead operation. See the

Using the Diagnostic Utility tabs

procedure.

•

If the Printhead does not cycle properly, see Resolving the Headlift Motor /
Sensor Error.

•

If the Printhead functions properly, continue to Step 6.

6

Replace the Ribbon Cartridge.

a. Press on the Resume button.

b. If the issue persists, continue to Step 7.

7

Remove the rear cover in order to check that the Ribbon Encoder Sensor is
securely connected to the J-4 Main Board connection and to the Encoder
Sensor.

a. Press on the Resume button.

b. If the issue persists, replace the Encoder Sensor.

Advertising