FARGO electronic DTC300 - Manual (Page 49)

RESTRICTED USE ONLY Fargo Electronics, Inc.
DTC400/DTC300/DTC300M Card Printer Service Manual (Rev. 1.3) 4-17
DTC400 Card Printer/Encoder Card Flipper Module
Upgrade Kit
This section provides directions on adding a Card Flipper Module to your existing DTC400
Card Printer/Encoder.
Introduction
Upgrade Kit includes:
• One (1) DTC400 Card Flipper Module
• Step-by-Step Instructional Guide
Firmware and Driver Requirements:
• Your DTC400 Card Printer/Encoder must have Firmware (Version 2.0.2 or later) and
Driver (Version 1.0.1 or later) prior to installing the Card Flipper Module.)
Tools Required:
• No. 2 Phillips Screwdriver