FARGO electronic DTC300 - Manual (Page 345)

RESTRICTED USE ONLY Fargo Electronics, Inc.
DTC400/DTC300/DTC300M Card Printer Service Manual (Rev. 1.3) 8-91
Replacing the Input Pusher (D900104)
Refer to Drawings D900110.
Tools Needed: Torx T-10 Screwdriver.
Parts Needed:
Estimated Repair Time: 15 minutes.
Steps Procedure
1
Caution: Turn off the Printer and unplug the power cord from the
Printer.
2 Remove the Rear Cover. See Replacing the Rear Cover (D900066) .
3 Remove the Input Door and Right End Cap. See Replacing the Input Door
Assembly (D900148) . See Replacing the Right End Cap (D900065-01 and –02) .