Printer setup and installation – FARGO electronic DTC300 User Manual
Page 35
RESTRICTED USE ONLY
Fargo Electronics, Inc.
DTC400/DTC300/DTC300M Card Printer Service Manual (Rev. 1.3)
4-3
Printer Setup and Installation
Choosing A Good Location
Follow these guidelines:
•
Place the unit in a location with adequate air circulation to prevent internal heat build up.
•
Use the Printer's dimensions as a guideline for the minimum clearances to the unit.
(Note: Allow for adequate clearance in front of the unit to accommodate the unit with its
Covers open.)
•
Do not install unit (a) near heat sources such as radiators or air ducts or (b) in a place
subject to direct sunlight, excessive dust, mechanical vibration or shock.
About Moisture Condensation
If the unit is brought directly from a cold to a warm location or is placed in a very damp room,
moisture may condense inside the unit. Should this occur, print quality may not be optimum.
Leave the unit turned OFF in a warm, dry room for several hours before using. This will allow
the moisture to evaporate.