FARGO electronic DTC300 - Manual (Page 320)

RESTRICTED USE ONLY Fargo Electronics, Inc.
DTC400/DTC300/DTC300M Card Printer Service Manual (Rev. 1.3) 8-66
Replacing the Headlift Motor Assembly (E000806) and the Headlift Cam
(D900075) (continued)
Steps Procedures
7 a. Use a Torx T-10 screwdriver to remove the four (4) screws (F000177) that
secure the Headlift Motor to the Printer, as shown below.
b. It will be necessary to manually turn the Headlift Cam in order to gain access
to all four screws, as shown below.
8 Position the Headlift Cam to ensure it is clear of the Headlift Sensor.
9 Partially pull the Headlift Motor Assembly (E000806) out the front of the Printer.
10 Disconnect the Headlift Motor power cable. See below.
11 Pull the Headlift Motor Assembly out of the Printer. See below.
12 Reverse to re-assemble.