FARGO electronic DTC300 - Manual (Page 353)

RESTRICTED USE ONLY Fargo Electronics, Inc.
DTC400/DTC300/DTC300M Card Printer Service Manual (Rev. 1.3) 8-99
Replacing the Cleaning Roller Lever (D900051)
Refer to Drawing D900110.
Tools Needed: Torx T-10 Screwdriver, Retaining Ring Pliers
Parts Needed: Card Cleaning Roller D900042, Retaining Ring 140048(X1),
Wave Washer 130951 (X1)
Estimated Repair Time: 30 minutes.
Steps Procedure
1
Caution: Turn off the Printer and unplug the power cord from the
Printer.
2 Remove the Rear Cover. See Replacing the Rear Cover (D900066) .
3 Remove the Input Door and Right End Cap. See Replacing the Input Door
Assembly (D900148) . See Replacing the Right End Cap (D900065-01 and –02) .
4 Remove the Card Output Door and Left End Cap. See Replacing the Output
Door Assembly (D900092) . See Replacing the Left End Cap (D900064) .
5 Use a Retaining Ring Pliers to remove the retaining ring (140048) from the Card
Exit Roller Shaft.
6 Slide the Card Exit Gear (810266) off of the Roller Shaft.
7 Remove the Wave Washer (130951).
Continued on the next page