FARGO electronic DTC300 - Manual (Page 354)

RESTRICTED USE ONLY Fargo Electronics, Inc.
DTC400/DTC300/DTC300M Card Printer Service Manual (Rev. 1.3) 8-100
Replacing the Cleaning Roller Lever (D900051) (continued)
Steps Procedure
8 Use a Small Flathead Screwdriver gently pry the Roller Shaft Locking Bushing
arm (D900046) out about 2mm.
9 Rotate the Roller Locking Shaft Bushing Counter Clockwise 1/8 of a turn, as
shown below.
10 Remove the Roller Shaft Locking Bushing.
11 Pull out the Pinch Roller (D900098).
12 Replace the Pinch Roller (D900098).
Caution: Be sure to add the retaining clip (140062) to the new
Cleaning Roller before it is inserted into the Printer.
13 Reverse to re-assemble.