FARGO electronic DTC300 - Manual (Page 298)

RESTRICTED USE ONLY Fargo Electronics, Inc.
DTC400/DTC300/DTC300M Card Printer Service Manual (Rev. 1.3) 8-44
Plate Removal
Replacing the Baseplate (D900000)
Refer to Drawing D900115.
Tools Needed: Torx T-10 Screwdriver, 7/32 nd nut driver, No. 2
Phillips Screwdriver, Needle Nose Pliers
Parts Needed: Baseplate (D900000)
Estimated Repair Time: 35 minutes.
Steps Procedure
1
Caution: Turn off the Printer and unplug the power cord from the
Printer.
2 Remove the Rear Cover. See Replacing the Rear Cover (D900066) .
3 Remove the Input Door and Right End Cap. See Replacing the Input Door
Assembly (D900148) . See Replacing the Right End Cap (D900065-01 and –02) .
4 Remove the Card Output Door and Left End Cap. See Replacing the Output
Door Assembly (D900092) . See Replacing the Left End Cap (D900064) .
Continued on the next page