FARGO electronic DTC300 - Manual (Page 164)

RESTRICTED USE ONLY Fargo Electronics, Inc.
DTC400/DTC300/DTC300M Card Printer Service Manual (Rev. 1.3) 6-35
Using the Overlay Heat (O) option (DTC300M)
Use this option to control the amount of heat the Printer uses when printing with the overlay
panel of a Ribbon. (Note: This control can be helpful for fine-tuning the transfer of overlay
onto the card.)
Step Procedure
1 Select KO - Premium Resin/Overlay under the Ribbon Type dropdown menu
to activate the Overlay Heat (0) slide. Check on the Print Both Sides
checkbox to activate all three slides (while also selecting KO - Premium
Resin/Overlay under the Ribbon Type dropdown menu). See below.
• Move the slide to the left to cause less heat to be used in the printing
process. (Note: Certain card types may need additional heat for better
transfer of the overlay material.)
OR
• Move the slide to the right to cause more heat to be used.