FARGO electronic DTC300 User Manual
Page 308
RESTRICTED USE ONLY
Fargo Electronics, Inc.
DTC400/DTC300/DTC300M Card Printer Service Manual (Rev. 1.3)
8-54
Replacing the Ribbon Motor Supply Assembly (D900121), O-Ring Drive Belt
(140212), Encoder (A000126) Sensor and Motor (D840980) (continued)
Steps Procedure
7
Use a Torx T-10 Screwdriver to remove the three (3) screws (F000178) that
secure the Ribbon Supply Motor Assembly to the Printer side plate.
8
Pull the Ribbon Take-up Motor assembly off the Printer side plate.
•
Note the position of the Ribbon and Head lift Sensor Cables for re-
assembly.
•
When reassembling a small Needle Nose pliers will be needed to reattach
the Ribbon Supply O-ring belt ( 140212)
Caution: Be sure to line the Encoder Wheel in the Encoder Wheel
Sensor during Re-Assembly.
Continued on the next page