FARGO electronic DTC300 - Manual (Page 364)

RESTRICTED USE ONLY Fargo Electronics, Inc.
DTC400/DTC300/DTC300M Card Printer Service Manual (Rev. 1.3) 8-110
Flipper Table Replacement
Replacing the Flipper Table Module Assembly (D900200)
Refer to Drawings D900200.
Tools Needed: Phillips Head Screwdriver.
Parts Needed: Step0er Motor Idler Puley shaft assembly D900089 (1), Stepper
Motor Drive Belt F00094.
Estimated Repair Time: 35 minutes.
Steps Procedure
1
Caution: Turn off the Printer and unplug the power cord from the
Printer.
2 Remove the Rear Cover (D90066) to the Printer.
Continued on the next page