FARGO electronic DTC300 - Manual (Page 287)

RESTRICTED USE ONLY Fargo Electronics, Inc.
DTC400/DTC300/DTC300M Card Printer Service Manual (Rev. 1.3) 8-33
Replacing the Input Tray (D900097)
Refer to Drawings D900148.
Tools Needed: Phillips Head Screwdriver.
Parts Needed: Input Tray D900097.
Estimated Repair Time: 5 minutes.
Steps Procedure
1
Caution: Turn off the Printer and unplug the power cord from the
Printer.
2 Open the Input Door.
3 Use a No. 2 Phillips screwdriver to remove the two (2) screws (130984) that
secure the Input Tray (D900097) and the Input Cover (D900064-02).
4 Pull the bottom of the Input Tray out and then down to remove.
5 Replace the Input Tray (D900097).
Continued on the next page