FARGO electronic DTC300 - Manual (Page 132)

RESTRICTED USE ONLY Fargo Electronics, Inc.
DTC400/DTC300/DTC300M Card Printer Service Manual (Rev. 1.3) 6-3
Selecting the Defined Area(s) function (continued) ___________________________________ 6-95
Selecting the Defined Area(s) function (continued) ___________________________________ 6-96
Selecting the Defined Area(s) function (continued) ___________________________________ 6-97
Selecting the Defined Area(s) function (continued) ___________________________________ 6-98
Selecting the Defined Area(s) function (continued) ___________________________________ 6-99
Selecting the Defined Area(s) function (continued) __________________________________ 6-100
Selecting the Print YMC under K and Print K Only options ______________________________ 6-101
Using the Printer Supplies tab (DTC400/DTC300/DTC300M) ______________________________ 6-102
Reviewing the Ribbon Information _________________________________________________ 6-103
Reviewing the Ribbon Level Indicator_______________________________________________ 6-104
Using the Printer Calibration Utility (DTC400/DTC300/DTC300M) _________________________ 6-105
Using the Image Darkness Option __________________________________________________ 6-106
Using the Print Top of Form Option_________________________________________________ 6-107
Using the Print End of Form Option_________________________________________________ 6-108
Using the Print Left of Form Option ________________________________________________ 6-109
Using the Magnetic Encoder Voltage Offset Option ____________________________________ 6-110
Adjusting the Hi-Co Voltage Offset _________________________________________________ 6-111
Adjusting the Lo-Co Voltage Offset_________________________________________________ 6-112
Using the Mag Top of Form Option _________________________________________________ 6-113
Using the Mag Top of Form Option (continued) _____________________________________ 6-114
Using the Ribbon Tension Option __________________________________________________ 6-115
Using the LCD Contrast Option ____________________________________________________ 6-115
Using the Flipper Home Offset Option_______________________________________________ 6-116
Using the Flipper Center Offset Option ______________________________________________ 6-116
Using the Flipper Smart Angle Offset Option _________________________________________ 6-117