FARGO electronic DTC300 User Manual

Page 362

Advertising
background image

RESTRICTED USE ONLY

Fargo Electronics, Inc.

DTC400/DTC300/DTC300M Card Printer Service Manual (Rev. 1.3)

8-108

Replacing the Stepper Motor Idler Pulley Shaft Assembly (D900089)
and the Stepper Motor Drive Belt (F000094)

Refer to Drawings D900077.

Tools Needed: Phillips Head Screwdriver.

Parts Needed: Steper Motor Idler Puley
shaft assembly D900089 (1), Stepper Motor
Drive Belt F00094.

Estimated Repair Time: 35 minutes.

Steps Procedure

1

Caution: Turn off the Printer and unplug the power cord from the

Printer.

2

Remove the Rear Cover. See

Replacing the Rear Cover (D900066)

.

3

Remove the Input Door and Right End Cap. See

Replacing the Input Door

Assembly (D900148)

. See

Replacing the Right End Cap (D900065-01 and –02)

.

4

Remove the Card Output Door and Left End Cap. See

Replacing the Output

Door Assembly (D900092)

. See

Replacing the Left End Cap (D900064)

.

5

Remove the Ribbon Take-up Motor Assembly. See

Replacing the Ribbon Take-

up Motor (D900086)

.

6

Remove the Stepper Motor Idler Pulley. See

Replacing the Stepper Motor Idler

Pulley (D840888) and the Platen Roller Drive Gear (D900047)

.

Continued on the next page

Advertising