Getting started, Setting up the hardware – Samsung CLX-3175FN User Manual

Page 120

Advertising
background image

23 _

Getting started

getting started

This chapter gives you step-by-step instructions for setting up the machine.

This chapter includes:

Setting up the hardware

System requirements

Setting up the network (CLX-3175N only)

Installing the software

Machine's basic settings

SETTING UP THE HARDWARE

This section shows the steps to set up the hardware which is explained in

the Quick Install Guide. Make sure you read Quick Install Guide and

complete following steps.
1.

Select a stable location.
Select a level, stable place with adequate space for air circulation. Allow

extra space to open covers and trays.

The area should be well-ventilated and away from direct sunlight or

sources of heat, cold, and humidity. Do not set the machine close to the

edge of your desk or table.

Printing is suitable for altitudes under 1,000 m (3,281 ft). Refer to the

altitude setting to optimize your printing. See "Altitude adjustment" on

page 27 for more information.

Place the machine on a flat, stable surface so that there is no incline

greater than 2 mm (0.08 inch). Otherwise, printing quality may be

affected.

2.

Unpack the machine and check all the enclosed items.

3.

Remove the tape holding the machine tightly.

4.

Load paper.

5.

Make sure that all the cables are connected to the machine.

6.

Turn the machine on.

When you move the machine, do not tilt or turn it upside down.

Otherwise, the inside of the machine may be contaminated by toner,

which can cause damage to the machine or bad print quality.

This equipment will be inoperable when mains power fails.

Advertising
This manual is related to the following products: