Installing the driver software – Samsung CLX-3175FN User Manual

Page 33

background image

Getting started_ 33


Click Wireless and Select Wizard. Then, click Next.


Select the one Network Name(SSID) in the list.


: SSID(Service Set Identifier) is a name that identifies a wireless

network. Access points and wireless devices attempting to connect

to a specific wireless network must use the same SSID. The SSID is


Operation Mode

: Operation Mode refers to the type of wireless


- Ad-hoc: allows wireless devices to communicate directly with each

other in a peer-to-peer environment.

- Infrastructure: allows wireless devices to communicate with each
other through an access point.


Click Next.

If wireless security setting window appears, enter the registered

password (network key) and click Next.

6. Wizard Setup Confirmation

window appears, please check your

wireless setup. If the setup is right, click Apply.


Click OK.

Now go to Installing the driver software.

Installing the driver software

You must install the printer driver software for printing. The software
includes drivers, applications, and other user friendly programs.

If your IP assignment method is DHCP and IP address can be changed

whenever machine is turned on, we recommend you to use the Bonjour

program. Go to the

download/, select the program Bonjour for Windows according to your

computer operating system, and install the program. In case of Mac OS X,

this program might be already installed in your PC. This program will allow

you to fix the network parameter automatically. This Bonjour program does

not support Linux.
If your IP assignment method is static, follow the steps below.

Insert the Printer Software CD-ROM into your CD-ROM drive. The CD-

ROM should automatically run, and an installation window appears.


Click Next.


will help you setup the wireless network configuration.

However, if you want to set the wireless network directly, select


If your network’s operation mode is Infrastructure, select the SSID

of the access point. If the operation mode is Ad-hoc, select the

machine’s SSID. Note that “airportthru” is the default SSID of your


Disconnect the network cable (standard or crossover). Your

machine should then start communicating wirelessly with the

network. In case of Ad-hoc mode, you can use a wireless LAN

and wired LAN simultaneously.

If Operation Mode is Infrastructure, you must disconnect the

network cable to activate wireless network after completing the

network setting.

The following procedure is based on Windows XP. The procedure

and popup window which appears during the installation may differ

depending on the operating system, machine features, or the

interface in use.

Make sure that the network setup for your machine is completed.

(See "Setting up the network" on page 25.) All applications should

be closed on your computer before beginning installation.

This manual is related to the following products: