KORG Triton Studio - Manual (Page 136)

125
Song Play
P0
P1
P2
P3
P7
P8
P9
0–1D: Save Template Song
This command saves the programs, the track parameters,
and the effect settings etc. as a user template song U00–15
(
☞Sequencer P0: 0–1H).
The settings that are saved here can also be loaded in
Sequencer mode.
0–1E: Set Location
By pressing the [LOCATE] key you can move to the location
specified here (
☞Sequencer P0: 0–1J).
0–3: Mixer 1–8
(Mixer T01–08)
0–4: Mixer 9–16
(Mixer T09–16)
Set the pan and volume for each track (channel).
0–3(4)a: Track Number, Program Category, Pan,
Volume
Track Number
Indicates the track number. ( ☞0–1c/2c)
Program Category
Displays part of the program category name used by the
track.
Pan [RND, L001...C064...R127]
Sets the panning for each track (channel) 1–16 ( ☞Sequencer
P0: 0–3b).
Tracks whose “Status” (1–1a/2a) is INT or BTH can
receive MIDI control change (CC#10) to control the pan-
pot. When receiving CC#10, a value of 0 or 1 will be far
left, 64 will be center, and 127 will be far right. Tracks 1–
16 will be controlled by MIDI channels 1–16 respec-
tively.
Volume [0...127]
Sets the volume of each track (channel) 1–16.
Tracks whose “Status” (1–1a/2a) is INT or BTH can
receive MIDI control change (CC#7) to control the vol-
ume. The actual volume of a track is determined by
multiplying the MIDI volume (CC#7) and expression
(CC#11) values. Tracks 1–16 will be controlled by MIDI
channels 1–16 respectively.
0–5: Preference
Here you can make settings for playing SMF files consecu-
tively, and make settings for the metronome.
0–5a: Next File
Specifies whether or not the next file will be played back in
succession when the currently selected SMF finishes play-
ing.
Chain to next file [Off, On]
On (checked): When the currently selected file finishes play-
ing, the next file will automatically be selected.
Auto Start [Off, On]
On (checked): When the currently selected SMF finishes
playing, the next file will automatically begin playing. This
is valid when “Chain to next file” is checked.
0–5b: Metronome Setup
Makes settings for the metronome.
Sound [On, Off]
On: The metronome will sound during playback. The sound
of the metronome will be output to the bus selected by “BUS
Select.”
BUS (Output) Select (BUS Select)
[L/R, L, R, 1, 2, 3, 4, 1/2, 3/4]
Specifies the output destination of the metronome sound
(
☞Sequence P0: 0–7b).
Level [000...127]
Sets the volume of the metronome.
0–1a
0–1b
0–1
0–3a
0–1a
0–1
0–5a
0–5b