KORG Triton Studio - Manual (Page 221)

210
When “Sw” = Moment, the speaker is rotating. It stops only when
you press the pedal or operate the joystick.
Rotation will occur when the value of the modulation
source is less than 64, and will stop when the value is 64 or
greater.
b: Sw
This parameter sets how the rotation speed (slow and fast) is
switched via the modulation source.
When “Sw” = Toggle, the speed is switched between slow and
fast each time you press the pedal or operate the joystick.
Slow/fast will alternate each time the value of the modula-
tion source exceeds 64.
When “Sw” = Moment, the speed is usually slow. It becomes fast
only when you press the pedal or operate the joystick.
When a value for the modulation source is less than 64,
“slow” speed is selected, and when the value is 64 or higher,
“fast” is selected.
c: Manual Speed Ctrl
If you wish to control the speaker rotation speed manually, not
switching between Slow and Fast, select the modulation source in
the “Manual Speed Ctrl” field. If manual control is not necessary,
set this field to Off.
d: Horn Acceleration, e: Rotor Acceleration
On a real rotary speaker, the rotation speed is accelerated or decel-
erated gradually after you switch the speed. The “Horn Accelera-
tion” parameter sets the speed at which the rotation is accelerated
or decelerated.
g: Mic Distance, g: Mic Spread
This is a simulation of stereo microphone settings.
Early reflection and delay effects
041: Early Reflections
This effect is only the early reflection part of a reverberation
sound, and adds presence to the sound. You can select one of
the four decay curves.
a: Type
This parameter selects the decay curve for the early reflection.
Mic Spread
Microphone Microphone
Mic Distance Mic Distance
Rotary Speaker (Top View)
Rotary Speaker - Mic Placement
ER/Delay
a
Type Sharp, Loose, Modulated, Reverse
Selects the decay curve for the early reflection
☞
b
ER Time [msec]
Sets the time length of early reflection 10...800msec
c
Pre Delay [msec] 0...200msec
Sets the time taken from the original sound to the first early reflection
d
EQ Trim 0...100
Sets the input level of EQ applied to the effect sound
e
Pre LEQ Gain [dB]
Sets the gain of Low EQ –15.0...+15.0dB
Pre HEQ Gain [dB]
Sets the gain of High EQ –15.0...+15.0dB
f
Wet/Dry Dry, 1:99...99:1, Wet
Sets the balance between the effect and dry sounds
Src Off...Tempo
Selects the modulation source of the effect balance
Amt
Sets the modulation amount of the effect balance –100...+100
Left
Right
Wet / Dry
Wet / Dry
Wet: Mono In - Stereo Out / Dry: Stereo In - Stereo Out
EQ Trim
+
EQ Trim
Pre Delay Early Reflections
LEQ HEQ
Sharp
Loose
Modulated
Early Reflections - Type
Reverse
Dry Pre Delay ER Time