KORG Triton Studio - Manual (Page 215)

204
031: Scratch
This effect is applied by recording the input signal and mov-
ing the modulation source. It simulates the sound of scratches
you can make using a turntable.
a: Scratch Source, b: Response
The Scratch Source parameter enables you to select the modula-
tion source that controls simulation. The value of the modulation
source corresponds to the playback position. The Response
parameter enables you to set the speed of the response to the
modulation source.
c: Envelope Select, c: Src, d: Threshold
When “Envelope Select” is set to D-mod, the input signal will be
recorded only when the modulation source value is 64 or higher.
When “Envelope Select” is set to Input, the input signal will be
recorded only when its level is over the Threshold value.
The maximum recording time is 1365msec. If this is exceeded, the
recorded data will start being erased from the top.
e: Response
This parameter enables you to set the speed of the response to the
end of recording. Set a smaller value when you are recording a
phrase or rhythm pattern, and set a higher value if you are record-
ing only one note.
f: Direct Mix
With Always On, a dry sound is usually output. With Always
Off
, dry sounds are not output. With Cross Fade, a dry sound is
usually output, and it is muted only when scratching.
Set Wet/Dry to Wet to use this parameter effectively.
a
Scratch Source Off...Tempo
Selects the modulation source for simulation control
☞
,
b
Response 0...100
Sets the speed of the response to the Scratch Source
☞
c
Envelope Select D-mod, Input
Selects whether the start and end of recording is controlled via the
modulation source or the input signal level
☞
,
Src Off...Tempo
Selects the modulation source that controls recording when Enve-
lope Select is set to D-mod
☞
d
Threshold 0...100
Sets the recording start level when Envelope Select is set to Input
☞
e
Response 0...100
Sets the speed of the response to the end of recording
☞
f
Direct Mix Always On, Always Off, Cross Fade
Selects how a dry sound is mixed
☞
g
Wet/Dry Dry, 1:99...99:1, Wet
Sets the balance between the effect and dry sounds
Src Off...Tempo
Selects the modulation source of the effect balance
Amt
Sets the modulation amount of the effect balance –100...+100
Input
D-mod
Envelope Select
D -mod
Envelope Control
Left
Right
Wet / Dry
Wet / Dry
Wet: Mono In - Mono Out / Dry: Stereo In - Stereo Out
+ Scratch
Direct
Mix
D -mod
Rec Control Scratch
+ Max Zero
Scratch!
D -mod
– Max
JS X
Ribbon
JS+Y
JS–Y
etc…
Zero + Max
Scratch Source
Recorded Sound
Scratch Source
Start Playback Position End