Installing the cdrw-1, Connect the cable you pulled out in step, Using the two screws you removed in step – KORG Triton Studio User Manual
Page 305: Attach the exb-mlan to the triton studio
294
5
Using the three mLAN installation screws (included with
the TRITON STUDIO), attach the mLAN installation
plate (also included with the TRITON STUDIO) to the
EXB-mLAN.
6
Connect the cable you pulled out in step
2
to the EXB-
mLAN connector. Firmly press the cable all the way into
the connector.
7
Using the two screws you removed in step
1
, attach the
EXB-mLAN to the TRITON STUDIO.
8
When all steps have been completed, turn on the power
and verify that the EXB-mLAN has been installed cor-
rectly. (“Checking after installation”
If you have installed the EXB-mLAN into the TRITON
STUDIO for the first time, you must perform the Initial-
ize operation. (
For details on connections between the EXB-mLAN and
external devices, refer to the “EXB-mLAN owner’s
manual.”
Installing the CDRW-1
Before you perform the installation, be sure to read the fore-
going section “Safety precautions” and “Please note when
installing an option board/memory.”
Never attempt to install an internal CD-R/RW drive
other than the CDRW-1.
While performing the installation, be careful not to cut
your hands on any sharp or pointed metal edges of the
TRITON STUDIO or the CDRW-1.
You must leave the AC power cable disconnected until
you have completed all steps of the installation.
1
Push off the CDRW-1 cover.
Slide the [EJECT] switch (located on the bottom of the
TRITON STUDIO) in the direction of the arrow, and the
drive bay cover on the side of the TRITON STUDIO will
be pushed out.
2
Remove the CDRW-1 cover.
Hook your fingertip on the edge of the cover that was
pushed out, and remove it in the direction of the arrow
shown in the diagram.
Forcefully pulling the cover toward yourself may dam-
age the cover.
Keep the cover you removed, since it will be needed if
you remove the CDRW-1.
3
Insert the CDRW-1.
Be sure that the drive is oriented in the correct direction.
48kHz WORD
CLOCK IN
OUT
DIGITAL
OUT(MAIN)
IN
S/P DIF
SCSI
SWITCH
PEDAL
DAMPER
THRU
OUT
IN
MIDI
ASSIGNABLE
LEVEL
2
1
MIC LINE
AUDIO INPU
T
( INDIVIDUAL
)
( MAIN)
2
1
R
L /MONO
4
3
AUDIO OUTP
UT
MAX MIN
EXB-mLAN
mLAN
installation plate
OUT(MAIN)
IN
S/P DIF
SCSI
LEVEL
2
1
MIC
LINE
AUDIO INPUT
( INDIVIDUAL )
( MAIN )
2
1
R
L /MONO
4
3
AUDIO OUTPUT
MAX
MIN
48kHz WORD
CLOCK IN
OUT
DIGITAL
OUT(MAIN)
IN
S/P DIF
SCSI
SWITCH
PEDAL
DAMPER
THRU
OUT
IN
MIDI
ASSIGNABLE
LEVEL
2
1
MIC LINE
AUDIO INPU
T
( INDIVIDUAL
)
( MAIN)
2
1
R
L /MONO
4
3
AUDIO OUTP
UT
MAX MIN
Viewed from below