4–3: moss setup (moss), 4–4: controller (control), 4–3: moss setup – KORG Triton Studio User Manual
Page 54: Displayed if the exb-moss option is, 4–4: controller, Specify the function of the [sw1] and
43
Combination
P0
P1
P2
P3
P4
P7
P8
P9
4–2a: Top Velocity, Top Slope, Bottom Slope,
Bottom Velocity
Top Velocity
[1…127]
Specifies the maximum velocity value that will sound each
timbre 1–8.
Top Slope
[0…120]
Specifies the number of velocity steps over which the origi-
nal volume will be reached, starting from the Top Velocity.
0:
The volume will be at the original value from the top
velocity.
120:
The volume will decrease as the velocity approaches the
top velocity.
Bottom Slope
[0…120]
Specifies the number of velocity steps over which the origi-
nal volume will be reached, starting from the Bottom Veloc-
ity.
0:
The volume will be at the original value from the bottom
velocity.
120:
The volume will decrease as the velocity approaches the
bottom velocity.
Bottom Velocity
[1…127]
Specifies the minimum velocity value that will sound each
timbre 1–8.
How volume will change according to keyboard location
“Top Velocity” and “Bottom Velocity” settings can also
be input by holding down the [ENTER] key and play-
ing a note on the keyboard.
4–3: MOSS Setup
(MOSS)
This page is displayed when the EXB-MOSS option has been
installed. For details refer to the owner’s manual included
with the EXB-MOSS.
4–4: Controller
(Control)
Here you can set the Combination mode functions of the
[SW1] key, [SW2] key, and the B-mode functions of REAL-
TIME CONTROL knobs [1]–[4].
4–4a: Panel Switch Assign
These settings assign the function of the [SW1] and [SW2]
keys (“SW1, SW2 Assign List”
Since the function assignments of the [SW1] and [SW2] keys
made for the program assigned to each timbre are not valid
inside of a combination, they must be newly set using these
parameters.
SW1 (SW1 Assign)
[Off, ..., After Touch Lock]
SW1 Mode
[Toggle, Momentary]
SW2 (SW2 Assign)
[Off, ..., After Touch Lock]
SW2 Mode
[Toggle, Momentary]
☞Program P1: 1–4a
4–4b: Realtime Control Knobs B-Assign
These settings assign functions (mainly various control
changes) to the B-mode of the REALTIME CONTROL knobs
[1]–[4] (“Realtime Control Knobs B–Assign List”
The functions you specify here will be controlled when you
operate the REALTIME CONTROL knobs [1]–[4] in B-mode.
Since the REALTIME CONTROL knob [1]–[4] function
assignments made for the program assigned to each timbre
are not valid inside a combination, they must be newly set
using these parameters.
Knob 1-B
[Off, ..., MIDI CC#95]
Knob 2-B
[Off, ..., MIDI CC#95]
Knob 3-B
[Off, ..., MIDI CC#95]
Knob 4-B
[Off, ..., MIDI CC#95]
☞Program P1: 1–4b
Bottom Slope
Top Slope
Bottom Velocity
Top Velocity
Velocity
Volume
0–1A
4–4a
4–4b
1–1a