KORG Triton Studio - Manual (Page 229)

218
059: P4EQ – Wah
(Parametric 4-Band EQ – Wah/Auto Wah)
This effect combines a mono-type four-band parametric
equalizer and a wah. You can change the order of the connec-
tion.
060: P4EQ – Cho/Flng
(Parametric 4-Band EQ – Chorus/Flanger)
This effect combines a mono-type four-band parametric
equalizer and a chorus/flanger.
i: Output Mode
When Wet Invert is selected, the right channel phase of the cho-
rus/flanger effect sound is inverted. This creates pseudo-stereo
effects and adds spread.
However, if a mono-input type effect is connected after this effect,
the left and right sounds may cancel each other, eliminating the
chorus/flanger effects.
a
[E] Trim
Sets the parametric EQ input level 0...100
b
[E] Band1 Cutoff [Hz]
Sets the center frequency of Band 1 20...1.00kHz
Q
Sets the bandwidth of Band 1 0.5...10.0
☞
Fx:006
Gain [dB]
Sets the gain of Band 1 –18...+18dB
c
[E] Band2 Cutoff [Hz]
Sets the center frequency of Band 2 50...5.00kHz
Q
Sets the bandwidth of Band 2 0.5...10.0
☞
Fx:006
Gain [dB]
Sets the gain of Band 2 –18...+18dB
d
[E] Band3 Cutoff [Hz]
Sets the center frequency for Band 3 300...10.00kHz
Q
Sets the bandwidth of Band 3 0.5...10.0
☞
Fx:006
Gain [dB]
Sets the gain of Band 3 –18...+18dB
e
[E] Band4 Cutoff [Hz]
Sets the center frequency for Band 4 500...20.00kHz
Q
Sets the bandwidth of Band 4 0.5...10.0
☞
Fx:006
Gain [dB]
Sets the gain of Band 4 –18...+18dB
f
[W] Frequency Bottom
Sets the lower limit of the wah center frequency 0...100
☞
Fx:009
Frequency Top
Sets the upper limit of the wah center frequency 0...100
☞
Fx:009
g
[W] Sweep Mode Auto, D-mod, LFO
Selects the control from auto-wah, modulation source, and LFO
☞
Fx:009,
Src Off...Tempo
Selects the modulation source for the wah when Sweep Mode=D-
mod
h
[W] LFO Frequency [Hz]
Sets the LFO speed 0.02...20.00Hz
Resonance
Sets the resonance amount 0...100
LPF
Switches the wah low pass filter on and off Off, On
i
Routing PEQ → WAH, WAH → PEQ
Changes the order of the parametric equalizer and wah connection
j
Wet/Dry Dry, 1:99...99:1, Wet
Sets the balance between the effect and dry sounds
Src Off...Tempo
Selects the modulation source of the effect balance
Amt
Sets the modulation amount of the effect balance –100...+100
Left
Right
Wet / Dry
Wet / Dry
Wet: Mono In - Mono Out / Dry: Stereo In - Stereo Out
Trim
+
Parametric 4Band EQ
Routing
Wah/Auto Wah
Wah
D -mod
Envelope
Sweep Mode
D-mod
Auto
LFO
LFO
a
[E] Trim
Sets the parametric EQ input level 0...100
b
[E] Band1 Cutoff [Hz]
Sets the center frequency of Band 1 20...1.00kHz
Q
Sets the bandwidth of Band 1 0.5...10.0
☞
Fx:006
Gain [dB]
Sets the gain of Band 1 –18...+18dB
c
[E] Band2 Cutoff [Hz]
Sets the center frequency of Band 2 50...5.00kHz
Q
Sets the bandwidth of Band 2 0.5...10.0
☞
Fx:006
Gain [dB]
Sets the gain of Band 2 –18...+18dB
d
[E] Band3 Cutoff [Hz]
Sets the center frequency for Band 3 300...10.00kHz
Q
Sets the bandwidth of Band 3 0.5...10.0
☞
Fx:006
Gain [dB]
Sets the gain of Band 3 –18...+18dB
e
[E] Band4 Cutoff [Hz]
Sets the center frequency for Band 4 500...20.00kHz
Q
Sets the bandwidth of Band 4 0.5...10.0
☞
Fx:006
Gain [dB]
Sets the gain of Band 4 –18...+18dB
f
[F] Delay Time [msec]
Sets the delay time 0.0...50.0msec
g
[F] LFO Frequency [Hz]
Sets the LFO speed 0.02...20.00Hz
LFO Waveform
Selects LFO Waveform Triangle, Sine
h
[F] Depth
Sets the depth of LFO modulation 0...100
Feedback
Sets the feedback amount –100...+100
☞
Fx:020
i
[F] Cho/Flng Wet/Dry –Wet...–2:98, Dry, 2:98...Wet
Sets the effect balance of the chorus/flanger
☞
Fx:010, 020
Output Mode Normal, Wet Invert
Selects the output mode for the chorus/flanger
☞
j
Wet/Dry Dry, 1:99...99:1, Wet
Sets the balance between the effect and dry sounds
Src Off...Tempo
Selects the modulation source of the effect balance
Amt
Sets the modulation amount of the effect balance –100...+100
Left
Right
Wet / Dry
Wet: Mono In - Stereo Out / Dry: Stereo In - Stereo Out
Trim
+
Parametric 4Band EQ Chorus/Flanger
Wet / Dry
Chorus/Flanger
Feedback
LFO: Tri / Sine
Cho/Flng Wet / Dry
Normal
Wet Invert
Output Mode
–
+