Nortel Networks BCM50 - Manual (Page 114)

114 Chapter 9 Connecting the cables to the BCM50 system
NN40020-302
4 Use a small slotted screwdriver to unscrew the wire hole screws on top of the terminal block.
5 Insert the bare wire ends (6 mm or 0.25 in.) in the appropriate holes on the sides of the
terminal block.
6 Tighten the screws to hold the wires in place.
7 Reinstall the terminal block on the patch panel.
8 Connect the wires (digital telephones, analog telephones, and analog trunks) to the patch
panel.
9 Connect cables to the main unit as required.
Next step
After you connect the cables to the BCM50 system, you can configure the initial parameters. For
information about configuring these parameters, see
Installing telephones and peripherals on page
115.