Nortel Networks BCM50 - Manual (Page 65)

Chapter 3 Viewing the BCM50 system LEDs 65
Installation and Maintenance Guide
Ethernet router LEDs (BCM50e and BCM50be only)
The three Ethernet router LEDs on the BCM50e and BCM50be main units monitor the router
status and the WAN port. The figure
Ethernet router LEDs on the BCM50e and BCM50be main
units (BCM50e shown) on page 65 shows the location of the three Ethernet router LEDs.
Figure 28 Ethernet router LEDs on the BCM50e and BCM50be main units (BCM50e shown)
The table LAN port LED indicators on page 65 describes the possible Ethernet router LED states.
Table 12 LAN port LED indicators
LED Status Description
Router status
On The router card is functioning properly.
Off The router card is not ready or malfunctioned.
Flashing The router card is rebooting.
WAN port yellow On The WAN port is operating at 10 Mb/s.
WAN port green On The WAN port is operating at 100 Mb/s.
Any WAN port
LED
Flashing
The WAN port is sending or receiving network data. The frequency of the
flashes increases with increased traffic.
Both WAN port
LEDs
Off
No connection.
Router
status WAN port
LEDs
WAN port LEDs