Nortel Networks BCM50 - Manual (Page 144)

144 Chapter 14 Using Element Manager to set the basic parameters
NN40020-302
The Add Account dialog box appears.
5 Configure the Add Account attributes. See the table Add Account attributes on page 144.
6 Click OK.
7 Repeat steps 4 to 6 to create more user accounts.
To configure SRG
1 From the Configuration tab, click the Resources folder to expand it.
2 Select Survivable Remote Gateway from the Resources folder.
3 Select the S1000 Main Office Settings tab.
4 Configure the S1000 Main Office Settings attributes. For more information about configuring
an SRG system, see the SRG50 Configuration Guide.
Next step
After you set the basic parameters, proceed to Completing the initial installation (optional) on page
151.
Table 30 Add Account attributes
Attribute Description
Description Enter a description for this account.
User ID Enter a descriptive name for the user or the user function.
Password Enter a password for this account.
Telset user ID (numeric) If the user performs administration through the Telset interface, enter a
number for the user ID.
Telset password (numeric) Enter a password for the Telset User ID.
Modem Callback Number If Callback is required, enter the number to which the system calls back to
verify the dial-up user access.
Modem Callback Passcode This is the code the system uses to confirm the callback is legitimate.
ISDN Callback Number If ISDN Callback is required, enter the number to which the system calls back
to verify the dial-up user access.
ISDN Callback Passcode This is the code the system uses to confirm that the ISDN callback is
legitimate.
Change Password On Login Select this check box to force the user to change the password upon first
login.
Change Password On Login
Telset Select this check box to force the user to change the Telset password upon
first login.