Nortel Networks BCM50 - Manual (Page 141)

Chapter 14 Using Element Manager to set the basic parameters 141
Installation and Maintenance Guide
To configure IP Phones
1 From the Configuration tab, click the Resources folder to expand it.
2 Select Telephony Resources.
3 From the Actual Type column, select IP & App Sets.
The Details for Module area appears in the lower pane with the IP Terminal Global Settings
tab as the default.
4 Configure the IP Terminal Global Settings attributes. See the table IP Terminal Global Settings
attributes on page 141.
WINS server address Specify the IP address of the WINS server.
BCM50 automatically assigns the value for this parameter. If the IP address or
subnet mask for the corresponding LAN interface changes, this value is
overwritten. Use caution when changing this value.
WINS node type Specify a client WINS node type.
The BCM50 system automatically sets this value to H-node on all DHCP
clients. This setting configures the DHCP client PCs to use P-node name
resolution before resorting to B-node name resolution.
Note: Use caution if you change this attribute.
Default gateway Specify the IP address of the default next-hop router.
BCM50 automatically assigns the value for this parameter. If the IP address or
subnet mask for the corresponding LAN interface changes, this value is
overwritten. Use caution when changing this value.
Lease time Specify the time, in seconds, for an address assignment until the client lease
expires.
The default is 259 200 seconds (72 hours).
Table 27 IP Terminal Global Settings attributes (Sheet 1 of 2)
Attribute Description
Enable registration Select this check box to allow new IP clients to register with the system.
WARNING: Remember to clear this check box when you finish registering the
new telephones.
Enable global registration
password To require the installer to enter a password when IP telephones are configured
and registered to the system, select this box.
If this box is not selected (disabled), a valid Telset user ID and password is
required to register IP phones.
Global password If you select the Enable Global Registration Password check box, enter the
password the installer enters on the IP telephone to connect to the system.
If this check box is empty, no password prompt occurs during registration.
Table 26 DHCP Server: General Settings attributes (Sheet 2 of 2)
Attribute Description