Wall-mount bracket – Nortel Networks BCM50 User Manual
Page 87
Chapter 7 Installing the main unit
87
Installation and Maintenance Guide
Figure 38 Wall-mount bracket
4
Prepare the wall-mount bracket by removing the alignment tabs:
•
If this is the only unit in the BCM50 system, remove the alignment tabs on the right side of
the wall-mount bracket.
•
If this is the last unit on a BCM50 system with multiple units, remove the alignment tabs
on the left side of the wall-mount bracket.
Place the additional wall-mount bracket on the backboard on the right side of the existing
wall-mount bracket. Use the alignment tabs to ensure the two wall-mount brackets are
properly aligned.
If these options do not meet your requirements, other options are available. For example, you
can route the Amphenol connector cable to the left of the unit, or you can route the cable
straight down the wall.
5
Attach the wall-mount bracket with five #8 x 2 cm (#8 x 0.75 in.) round-head wood screws:
a
Install one screw in the backboard. Do not tighten the screw head against the backboard.
Leave approximately 0.5 cm (0.25 in.) of the screw exposed from the backboard.
b
Hang the wall-mount bracket on the mounting screw.
c
Use a level to make sure the wall-mount bracket is level.
d
Install two screws into the screw holes in the wall-mount bracket. See the figure
e
Tighten the wood screws against the wall-mount bracket.
f
Open the cable-management door.
1
1
1
2
2
2
Note
: When you use three screws, Nortel
recommends installing the screws in the three
holes labeled “1” or the three holes labeled “2”.
Attach the wall-mount bracket with 5 screws:
• Two screws mount through the cable trough
(open the cable-management door).
• Three screws mount as shown in the figure.