Nortel Networks BCM50 - Manual (Page 138)

138 Chapter 14 Using Element Manager to set the basic parameters
NN40020-302
To configure the LAN IP address
1 From the Configuration tab, click the System folder to expand it.
2 Select IP Subsystem.
3 Select the General Settings tab. It is normally selected by default.
4 From the IP Settings area, click Modify.
The Modify IP Settings dialog box appears.
5 Configure the IP Settings attributes. See the table Modify IP Settings attributes on page 138.
6 Click OK.
To configure the modem
1 From the Configuration tab, click the Administrator Access folder to expand it.
2 Select Modem.
3 Select the Enable modem check box to enable the modem.
For more information about modem configuration, see the Networking Configuration Guide.
To configure the startup template for telephony services
1 From the Administration tab, click the Utilities folder to expand it.
2 Select Reset.
3 Click Cold Reset Telephony Services.
The Cold Reset Telephony dialog box appears.
Table 23 Modify IP Settings attributes
Attribute Description
Obtain IP address dynamically If this is selected, the BCM50 system attempts to use IP address
information from a DHCP server.
If this is not selected, you must enter values for static IP address, IP
subnet mask, and Default gateway.
IP address The IP address of the BCM50 system.
IP subnet mask The subnet mask used by the BCM50 system.
Default gateway The gateway used by the BCM50 system.
Note: If you modify any of the attributes, then the Element Manager session disconnects.
Note: This procedure erases all the telephony programming that is currently on
the BCM50 system.