Nortel Networks BCM50 - Manual (Page 92)

92 Chapter 7 Installing the main unit
NN40020-302
Figure 44 Location for feet on the bottom of the BCM50 unit
3 Position the BCM50 unit on a table or shelf. Make sure you leave enough space around the
unit for ventilation and access to the cables.
4 If the BCM50 system has additional units, you can install the other units on top of, or beside,
the existing BCM50 unit.
• To install the additional units beside the existing unit, repeat steps 1 to 3 for each unit.
• To install the additional units on top of the existing unit, see the procedure To install a
BCM50 unit on top of another unit on page 85.
5 Install the power supply next to the BCM50 unit.
The power supply must be within 1.5 m (5 feet) of the BCM50 unit and within 1.5 m
(5 feet) of the AC power outlet (wall outlet or UPS).
6 Repeat step 5 for each power supply.
Next step
If you install an expansion unit, proceed to Installing an expansion unit on page 93.
Otherwise, proceed to Connecting the cables to the BCM50 system on page 99.
Attach feet here