Nortel Networks BCM50 - Manual (Page 131)

Chapter 13 Using Telset Administration to set the basic parameters 131
Installation and Maintenance Guide
To configure the IP address
1 Select Feature 9*8 from a two-line display telephone.
2 Enter the following user ID and password:
User ID: SETNNA
Password: CONFIG
The numerical values of the user ID and password are 738662 and 266344, respectively.
3 Press NEXT to scroll through the menu and select IP Address.
4 Press OK.
5 Press CHNGE to modify the IP settings. The display screen shows whether DHCP is enabled
or disabled.
6 Perform one of the following tasks:
a If DHCP is currently enabled:
• Press DIS to disable DHCP. You can modify the IP Address, Subnet Mask, and Default
Gateway. However, these settings have no effect if the system is disabled.
• Press IP to modify the following IP settings:
— IP Address
— Subnet Mask
— Default Gateway
b If DHCP is currently disabled:
• Press ENL to enable DHCP. The system must reboot to enable DHCP.
• Press IP to modify the IP settings. You can modify the IP Address, Subnet Mask, and
Default Gateway. However, these settings have no effect if the system is disabled.
7 Press Back to reboot the system.
To configure the modem
1 Select Feature 9*8 from a two-line display telephone.
2 Enter the following user ID and password:
User ID: SETNNA
Password: CONFIG
The numerical values of the user ID and password are 738662 and 266344, respectively.
3 Press NEXT to scroll through the menu and select Modem.
4 Press OK. The display screen shows whether the modem is enabled or disabled.
5 Perform one of the following tasks:
a If the modem is disabled, press ENL to enable the modem.
b If the modem is enabled, press DIS to disable the modem.
For more information about modem configuration, see the Networking Configuration Guide.