Nortel Networks BCM50 - Manual (Page 149)

Chapter 15 Using the Startup Profile to configure parameters 149
Installation and Maintenance Guide
If an error occurs, the status LED flashes red. View the log file (written to the USB storage
device) for a description of the Startup Profile errors. If no errors exist, the BCM50 system
automatically reboots to complete the system configuration. After the reboot finishes, the
power and status LEDs are solid green.
4 Remove the USB storage device from the USB port on the BCM50 or the USB hub.
5 Connect the 25-pair cable to the RJ-21 telephony connector on the BCM50 main unit.
The Startup Profile is now loaded on your BCM50 system.
Next step
After you load the Startup Profile, you can connect the data networking cables. For information
about connecting these cables, see
Completing the initial installation (optional) on page 151.
Note: The Startup Profile works only on a BCM50 system with no keycode
loaded. After a keycode is loaded, the Startup Profile does not work. This
condition prevents unintentional overwriting of the parameters of a configured
system.
Note: Make sure the bootup sequence is complete before removing the USB
storage device from the BCM50 system.