Ricoh AP2610N - Manual (Page 147)

Loading Paper and Other Media
45
3
DDDD
Load paper into the paper tray
with the print side down.
Important
❒ Confirm that the top of the stack
is not higher than the limit mark
inside the tray.
❒ Confirm that paper fits under
the rear guide.
EEEE
While lifting the front of the tray,
place the tray into the printer.
Then slide it inside until it stops.
Important
❒ Do not slide the paper tray in
with force. If you do, the front
and side guides might move.
Loading Envelopes
As there are many kinds of envelopes,
be sure to check if those to be used are
supported by this printer.
Reference
For more information about enve-
lopes, see p.33 “Types of Paper and
Other Media”.
Important
❒ Even when the optional Envelope
Feeder Unit is not installed, you
can select the sizes for the enve-
lopes for Tray 2 using the control
panel. However, you cannot load
the envelopes until the optional
Envelope Feeder Unit is installed.
❒ To install the Envelope Feeder
Unit, the optional Paper Feed Unit
must be installed. See “Envelope
Feeder Type 2600” in the Setup
Guide.
Loading envelopes onto the Bypass Tray
Reference
With the Bypass Tray, you can
load up to 10 envelopes at the same
time. For more information about
envelopes, see p.33 “Types of Pa-
per and Other Media”.
AAAA
Open the Bypass Tray.
ZCEY260J
ZDDP340E
ZGDY190J