Ricoh AP2610N - Manual (Page 456)

UNIX Configuration
4
1
E
Enter the IP address of the printer.
Enter Printer host IP address <xxx.xxx.xxx.xxx> [return=skip]:
192.168.15.16
Note
❒ The IP address will be added to the /etc/hosts file.
❒ If the host name of the printer has already been configured, ignore and
press the {RETURN} key. Nothing is added to the /etc/hosts file.
F
Enter the host name of the printer.
Enter Printer host name : nphost
Note
❒ The host name will be added to the /etc/hosts file.
❒ If no IP address was entered in step E, nothing is added to the /etc/hosts
file.
G
Configure the printer name.
Enter logical printer name [default nphost_prn]
If you want to use the default name, press the {RETURN} key. If you want to
change this name, enter a new name.
Note
❒ The host name entered in step F followed by “_prn” appears in “default”.
H
Set the print option.
Enter remote printer name [default lp]:
• Press the {RETURN} key, print with PCL or PostScript is enabled.
• If you enter “text”, text printing is enabled.
If you enter “text”, printing with PCL and PostScript is unavailable.
Enter remote printer name [default lp]:text
Limitation
❒ You can enter up to 14 characters for HP-UX 11.0, 256 for Solaris 8, and 51
for Red Hat Linux 6.2.
Setup with the installation shell script is finished. If you enter the IP address
in step
E, the following message appears.
hosts file is modified
I
Make a test print to confirm that the settings are correct.
# lpr -Pnp file_name
# lp -d np file_name
For more information about lpr and lp, see P.10 “Printing Method”.