Ricoh AP2610N - Manual (Page 37)

Network Interface Board Type 2610
23
2
KKKK
Match the controller board to the
top and bottom rail using the "
T T T T"
mark, and then slide it into the
printer slowly until it stops.
LLLL
Push back the handle of the con-
troller board until it clicks.
MMMM
Fasten the controller board to the
printer with the two screws.
Note
❒ If the Duplex Unit is not at-
tached, go to step O .
NNNN
While aligning the power cord to
the left side groove of the Duplex
Unit, slide the Duplex Unit in un-
til it is connected to the printer.
OOOO
Plug the printer's power cord
back into the wall outlet, and then
turn on the power switch.
ZGDX253J
ZGDX380J
ZGDX271J
ZGDX241J