Ricoh AP2610N - Manual (Page 380)

Appendix
90
7
Setting SSID
AAAA
Click [IEEE 802.11b].
BBBB
Enter a value in [SSID].
Important
❒ If you cannot connect after mak-
ing SSID and WEP key settings,
select "WL.LAN Defaults" from
the control panel, and then set
IEEE 802.11b (wireless LAN)
from the beginning. For more
information about how to use
the control panel, see the Setup
Guide.
Note
❒ The character strings to be set
are in the range ASCII 0x20-
0x7e and the SSID is case-sensi-
tive to 32 bytes.
If using the WEP key, see p.90 “Set-
ting the WEP Key”.
If not using the WEP key, seep.90
“Applying the Settings”.
Setting the WEP Key
AAAA
Click [IEEE 802.11b].
BBBB
Enter a value in [WEPKey].
Note
❒ You can set only 10 hexadecimal
character strings.
CCCC
Change to enable use of WEP.
See p.90 “Using WEP”.
Using WEP
Important
❒ To enable the WEP key, be sure to
first enter a value for the WEP key.
Seep.90 “Setting the WEP Key”.
❒ With some products, depending
on the access point or IEEE 802.11b
card in use, it is possible to set
more than one WEP key. In this
case, make the first key the same as
the WEP key set in the printer.
AAAA
Click [IEEE 802.11b].
BBBB
Change [Encryption] to [Enable].
CCCC
Apply all the settings.
See p.90 “Applying the Settings”.
Important
❒ If you cannot connect after mak-
ing SSID and WEP key settings,
select "WL.LAN Defaults", and
then make setting for IEEE
802.11b (wireless LAN) from
the beginning. For more infor-
mation about how to use the
control panel, see the Setup
Guide.
Applying the Settings
AAAA
Click [Refresh] or [Reload].
The settings are transmitted.
Note
❒ To verify the settings, click [Con-
fig Reference] , and then click
[IEEE 802.11b] .
BBBB
Exit the Web browser.