Ricoh AP2610N - Manual (Page 165)

Error & Status Messages on the Control Panel
63
5
Hardware Problem
HDD
An error has occurred in the
optional Hard Disk Drive. First, turn the power switch
off and then on, If the message
appears again, call your sales
or service representative.
Turn off the power switch. Re-
place the Hard Disk Drive and
turn on the power switch. See
“Hard Disk Drive Type 2600” in
the Setup Guide.
Turn off the power switch. Re-
move the Hard Disk Drive
and turn on the power switch.
Note
❒ If the Hard Disk Drive is
not installed, you cannot
send the sample print job,
locked print job and
download the font to Hard
Disk Drive using the PS
Utility for Mac.
Hardware Problem
IEEE1394
An error has occurred in the
optional 1394 Interface Unit. First, turn the power switch
off and then on, If the message
appears again, call your sales
or service representative.
Turn off the power switch. Re-
place the 1394 Interface Unit
and turn on the power switch.
See “1394 Interface Unit Type
4510” in the Setup Guide.
Turn off the power switch, re-
move the 1394 Interface Unit
and turn on the power switch.
Note
❒ If you remove the 1394 In-
terface Unit, you cannot
send print jobs via the 1394
Interface Unit. You can
only send print jobs to the
printer via the parallel ca-
ble connection.
Hardware Problem
IEEE 802.11b An error has occurred in the
optional 802.11b Interface
Unit. Replace the IEEE 802.11b
board.
Messages/Second messages Description Solution