Ricoh AP2610N - Manual (Page 306)

Windows 2000 Configuration
16
2
CCCC
Make sure that the“Internet Protocol (TCP/IP)” is selected in the [Compo-
nents checked are used by this connection:]
box on the [General] tab.
Note
❒ Select the TCP/IP protocol box if it is not already selected.
❒ If the TCP/IP protocol is not installed, click [Install] on the [General] tab to
install it. For more information about installing the TCP/IP protocol, see
Windows 2000 Help.
DDDD
Configure the TCP/IP protocol with the appropriate IP address, subnet
mask and other settings.
Check with the network administrator that the settings are correct.
Configuring NetBEUI for Printing
Follow these instructions to configure the Network Interface Board and Win-
dows 2000 to use the NetBEUI protocol.
Preparation
To use NetBEUI, use the SmartNetMonitor for Client port.
Configuring the machine
Configure the machine to use the NetBEUI protocol.
• Make sure that the NetBEUI protocol is set to active. (The default is active.)
Reference
For more information about how to make the above settings, see the Setup
Guide.
Configuring a Windows 2000 computer
Follow these steps to configure a Windows 2000 computer to use the NetBEUI
protocol.
AAAA
Click [Start] on the taskbar, point to [Settings], and then click [Network and
Dial-up Connections]
.
BBBB
Click [Local Area Connection]. On the [General] tab, click [Properties].
CCCC
Make sure that the“NetBEUI Protocol” is selected in the [Components
checked are used by this connection:]
box on the [General] tab.
Note
❒ Select the NetBEUI protocol box if it is not already selected.
❒ If the NetBEUI protocol is not installed, click [Install] on the [General] tab
and install it. For more information about installing the NetBEUI protocol,
see Windows 2000 Help.